60 cab Produkttechnik GmbH & Co KG / Tharo Systems, Inc.Printhead PositionThe "Printhead position" parameter defines the location of the print image onthe label in x- and y-direction. The parameter should only be altered if you areusing the same label formats on several printers, and you find the print imagelocated differently on the labels when they were printed on another printer.X-OffsetWith this parameter the location of the print image can be shifted across to thelabel path. It is possible to set a shifting untiI .39 in (9.9 mm) outward in theSetup.NOTICE !The difference between the width of the printhead and the width of thelabel set in the software may not be smaller than the X-offset value set inthe setup. In this case the shifting is only applied for the difference value.This limitation is necessary to guarantee the printing of the whole label.The setting of a negative X-offset value (shifting the print image inward) is notpossible.Y-OffsetWith this parameter the location of the print image can be shifted in thedirection of the label path (range from -.39 to +.39 or -9.9 mm to +9.9 mm).When the offset values are positive the printing in the direction of the label pathstarts later.NOTICE !A change of the printhead position value influences the tear-off and thecut position. For that reason alter the values of the parameters "Peelposition" and "Cut position" by the same amount as the "Printheadposition" but in the opposite direction.Adjustments for various print jobs may also be carried out via software whichprovides an additional offset value. There are additional offset values in x- andy-direction.Any front panel value and software command value are totaled together forprinting.The current field to be changed is flashing.
