10 104 Operation4.1 Switching on the Machine Switch the machine on. The mains power switch (1) is situated at the rear of the machine in the mains module.After switching on the display (2) of the control panel shows "0".15342697108Fig. 7 Operation4.2 Setting the Speed of Separationi Notice!The speed may be switched during operation as well as in Standby mode. In the latter case, the set speedwill be shown as long as the SPEED key (3) is being pressed. Press the SPEED key (3) if necessary several times. The key may be reached with a pointed tool through thehole (4).The speed may be adjusted in three levels: Display "1": 100 mm/sDisplay "2": 200 mm/sDisplay "3": 300 mm/s4.3 Separating the PCB's! Warning!Risk of hand injury ! Wear protective gloves while PCB separating.i Notice!When using the machine for the first time, degrease the blades with a soft cloth.1. Press Start/Stop key (5).The lower blade (10) starts to rotate at its preset speed. The preset speed will be shown at the display (2).2. Lay the PCB (8) onto the lower guide (9).3. Slide the PCB forwards between upper and lower guide (6,9) to the blades (7,10).The rotating lower blade (10) will catch hold of the pre-scored PCB, which will be separated as it is transportedbetween the two blades.4. In order to return to Standby mode, press the Start/Stop key. The motor will be switched off and the lower bladewill stop.i Notice!When the machine is switched off, it is possible to separate PCB’s manually. Insert the PCB between upper and lower guide (6,9) and then push it gently between the blades (10,11 ).