CAMBRIONIX SuperSync15 User Manual

Also see for SS15: Manual User manual User manual User manual User manual

SS15Page 19 of 38For Linux® systems, download the install files from the website at the above link. Oncedownloaded, you can either install it from the desktop GUI or the command line via:sudo apt install/.after this command you will need to enter the file name that has just been downloaded fromour website.5.5.2LiveViewerLiveViewer is an application downloaded from www.cambrionix.com/products/liveviewer.Once downloaded and installed on the host computer, LiveViewer allows you to switch theports on and off and set the port mode. LiveViewer’s home page shows the followinginformation about all the ports:•Status (Attached/disconnected(•Mode (Charge/Sync/Off(•Profile (Charging profile(•Duration (How long the device has been attached(•End time (Time the battery reaches a threshold (full) level(•Current (Quick charge current in mA(•Energy (Present energy rate(Tick boxes adjacent to each port symbol allow that port mode to be changed when the "enableport controls" is selected. When the port is in Sync mode, only instantaneous current can bemonitored through LiveViewer. When the port is in Charge mode, the charge profile, current,energy rate, charge duration and end time are displayed. In addition to individual portinformation and control, LiveViewer shows the hub rail voltages, time since switched on, totalcurrent and power, and temperature. Further details on LiveViewer are available on ourwebsite.NVRAM settingsWithin your hub, there are some specific controllable settings called "non-volatileRAM settings", which are referred to as NVRAM settings. These control a variety of differentsettings on your SS15.You can navigate to the NVRAM settings by opening LiveViewer and selecting the hub you wantto connect to. Once you have chosen the connected hub, navigate to the below icon on the topright of the screen from LiveViewer and then clicking advanced on the bottom of the page