CAME GARD series Installation Manual
Also see for GARD series: Installation manualInstallation manualManualInstallation manualManual
                            | |
Contents
| 
Page 2 62 6 - Manual Code: 119 G V2 0119 G V2 0 ver. 2.12.1 12/2011 © CAME cancelli automatici s.p.a. - The data and information in this manual may be changed at any time and without obligation on the part of Came Cancelli Automatici S.p.a. to notify said changes.ENGLISHIn its premises, CAME Cancelli Automatici S.p.A. implements an Environmental Management System certified in compliance withthe UNI EN ISO 14001 standard to ensure environmental protection.Please help us to safeguard the environment. At CAME we believe this to be one of the fundamentals in its market operations and deve-lopment strategies. Just follow these short disposal instructions:DISPOSING OF THE PACKAGINGThe components of the packaging (i.e. cardboard, plastic, etc.) are solid urban waste and may be disposed of without much trouble, simplyby separating them for recycling.Before proceeding it is always a good idea to check your local legislation on the matter.DO NOT DISPOSE OF IN THE NATURE!PRODUCT DISPOSALOur products are made up of various materials.Most of these (aluminium, plastic, iron, electric cables) are solid urban waste.These canbe disposed of at local solid waste management dumps or recycling plants.Other components (i.e. electronic cards, remote control batteries, etc. )may contain hazardous substances.These must therefore be handed over the specially authorised disposal firms.Before proceeding it is always a good idea to check your local legislation on the matter.DO NOT DISPOSE OF IN THE NATURE!Trouble shootingDismantling and disposalPROBLEM ReferenceChecksCHECKSThe operator neither opens nor closes 1-2-3-4-6-8-18 1 - Lock the inspection hatch using the key and checkthe release lock2 - 2 - Deactivate the Maintained action function viaDip-switch3 - 3 - Check power source and fuses4 - 4 - The N.C. safety contacts are open6 - 6 - Deactivate the master-slave function7 - 7 - Check balancing and tighteness of springs8 - 8 - Deactivate the Obstacle detection function viaDip-switch9 - 9 - Check opening endpoint10 - 10 - Check closing endpoint11 - 11 - Activate the Automatic Closing function viaDip-switch12 - Check for the proper direction of travel13 - Check the command devices14 - 43 - Cut off and bring back power to card orcheck the TOP/TAM jumper on the AF43S card15 -15 - Check the Arm length/Applied Accessoriesratio16 - 16 - Memorise the new radio code18 - Adjust sensitivity22 - Insert or duplicate the same code in all transmit-ters transmitters23 - Activate the photocell via Dip-switch24 - Connect the photocells in series and not in paral-lel fashion25 - Check the batteries26 - Respect the polarities when powering up thephotocellsThe operator opens but doesn't close 4-7-10The operator closes but doesn't open 4-7-9The operator does not carry out the auto-matic closing11-12-13The transmitter doesn't work 2-14-16The operator inverts the direction of travel 7-18Only one transmitter works 22The photocell does not work 12-23-24The LED flashes quickly 4Il LED stays on 13The operator does not fully complete cycle 7Cannot balance the arm 7-15The operator does not decelerate 7-15The operator does not run on the emer-gency batteries8-25-26The operator is slow when starting 7 |
Related manuals for CAME GARD series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine