CAME GARD series Installation Manual
Also see for GARD series: Installation manualInstallation manualManualInstallation manualManual
                            | |
Contents
| 
CAME1511794312108626Page 77 - Manual Code: 119 G V 2 0119 G V2 0 ver. 2.12.1 12/2011 © CAME cancelli automatici s.p.a. - The data and information in this manual may be changed at any time and without obligation on the part of Came Cancelli Automatici S.p.a. to notify said changes.ENGLISH1) 001G3750 barriers2) Flashing light3) Semi-elliptical4) Luminous cord5) Red reflective strips6) PhotocellsStandard installationTypes of cables and thicknessesN.B. If cables are of a different length than that shown in the table, determine the cable section based on the actual draw and the numberof connected devices and according the what is set forth in the CEI EN 60204-1 code of regualtions.For connections featuring several loads on the same line (i.e. sequential ones), the dimensions shown on the table must be reconsideredaccording to the total draw and actual distances. When connecting products not featured in this manual, only refer to the literature ac-companying such products.7) Support for photocells8) Small column for photocells9) Fixed support10) Command device (i.e. keyboard, magnetic key, transponder, etc.)Stand for command deviceMetal mass detectorConnection Cable type Cable length1 < 10 mCable length10 < 20 mCable length20 < 30 m230 V power source to control panelFROR CEI20-22CEI EN50267-2-13G x 1.5 mm 2 3G x 1,5 mm 2 3G x 2,5 mm 2Motor power supply (V) 24 V 3G x 1.5 mm 2 3G x 1.5 mm 2 3G x 2.5 mm 2Flashing light 2 x 1.5 mm 2 2 x 1.5 mm 2 2 x 1.5 mm 2TX photocells 2 x 1.5 mm 2 2 x 0.5 mm 2 2 x 0.5 mm 2RX photocells 4 x 0.5 mm 2 4 x 0.5 mm 2 4 x 0.5 mm 2Accessories power source 2 x 0.5 mm 2 2 x 0.5 mm 2 2 x 1 mm 2Safety and command devices 2 x 0.5 mm 2 2 x 0.5 mm 2 2 x 0.5 mm 2Connecting the antenna RG58 max. 10 m |
Related manuals for CAME GARD series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine