Cabletron Systems 6E233-49 SmartSwitch 6000 User Manual

Also see for 6E233-49 SmartSwitch 6000: Installation & user guide

Contents

ixSAFETY INFORMATIONCLASS 1 LASER TRANSCEIVERSTHE GPIM-01 AND GPIM-09 GIGABIT ETHERNET MODULESUSE CLASS 1 LASER TRANSCEIVERS.READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATINGTHESE MODULES.The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loopeliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any useradjustment. Class 1 Laser transceivers comply with the following safety standards:• 21 CFR 1040.10 and 1040.11 U.S. Department of Health and Human Services (FDA).• IEC Publication 825 (International Electrotechnical Commission).• CENELEC EN 60825 (European Committee for Electrotechnical Standardization).When operating within their performance limitations, laser transceiver output meets the Class 1 accessible emission limitof all three standards. Class 1 levels of laser radiation are not considered hazardous.SAFETY INFORMATIONCLASS 1 LASER TRANSCEIVERSLASER RADIATION AND CONNECTORSWhen the connector is in place, all laser radiation remains within the fiber. The maximum amount of radiant powerexiting the fiber (under normal conditions) is -12.6 dBm or 55 x 10-6 watts.Removing the optical connector from the transceiver allows laser radiation to emit directly from the optical port. Themaximum radiance from the optical port (under worst case conditions) is0.8 W cm-2 or 8 x 103 W m 2 sr-1.Do not use optical instruments to view the laser output. The use of optical instruments to view laser outputincreases eye hazard. When viewing the output optical port, power must be removed from the network adapter.Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com