Cabletron Systems 9F426-03 User Manual

Also see for 9F426-03: Appendix Appendix

Contents

Cabletron Systems 9F426-03 User Manual Manual pdf 15 page image

2-1Chapter 2Installing the SmartSwitch 9000ModuleThis module uses FPIMs for the front panel connections. They are not shippedwith the module and must be purchased separately. For more information onFPIMs, see Appendix A.Unpacking the Module1. Carefully remove the module from the shipping box. (Save the box andpacking materials in the event the module must be reshipped.)2. Remove the module from the plastic bag. Observe all precautions to preventdamage from Electrostatic Discharge (ESD).3. Carefully examine the module, checking for damage. If any damage exists,DO NOT install the module. Contact Cabletron Systems Technical Supportimmediately.Installing an FPIMThe 9F426-03 SmartSwitch module is shipped without FPIMs. To install an FPIM,follow the procedure below:1. Remove the module if it is installed in the SmartSwitch 9000 chassis.2. Remove the blank front cover over the FPIM slot.3. Install the FPIM as shown in Figure 2-1. Ensure that the rear connector isseated firmly before tightening the two mounting screws.