Cabletron Systems CyberSWITCH CSX101 User's Information Manual

CyberSWITCH 100 Advanced User Information iNoticeCabletron Systems reserves the right to make changes in specifications and other information contained in this document without priornotice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.The hardware, firmware, or software described in this manual is subject to change without notice.IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, ORCONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF ORRELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEENADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES. Copyright September 1997, by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005All Rights ReservedPrinted in the United States of AmericaPart Number: 9031944-01CyberSWITCH and QuickSET are registered trademarks of Cabletron Systems, Inc.All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.FCC NoticeNote: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment.DOC NoticeThis product conforms with Canadian Class B emissions regulations.Ce produit se conforme aux réglements d’émision Canadienne classe B.