Chapter 4: The System Level ScreenPage 4-4ESXMIM/ESXMIM-F2 Local Management Guide3. Press ENTER to set the system clock.4. Use the arrow keys to highlight the SAVE command field at thebottom of the screen and press ENTER.If the time entered was a valid format, the Event Message field at thetop of the screen displays “SAVED OK”. If the entry was not valid,Local Management does not alter the current value and refreshes theSystem Time field with the previous value.4.4 SETTING THE HOST IP ADDRESSTo set the host IP address, perform the following steps:1. Use the arrow keys to highlight the Host IP Address field.2. Enter the IP address using Decimal Dotted Notation (DDN) format.For example: 134.141.25.173. Press ENTER. If the IP address entered was a valid format, the cursorreturns to the beginning of the Host IP Address field. If the entry wasnot valid, the Event Message field displays “INVALID IP ADDRESSOR FORMAT ENTERED”. Local Management does not alter thecurrent value and refreshes the Host IP Address field with the previousvalue.4. Use the arrow keys to highlight the SAVE command field.5. Press ENTER. The Event Message field at the top of the screendisplays “SAVED OK”. This message flashes briefly, then the EventMessage line will display “System Reboot in Progress...”. LocalManagement will be terminated and the screen will freeze while theESXMIM resets.NOTEChanging the ESXMIM IP address requires a reset of themodule. LM will automatically reset the ESXMIM, which will gothrough startup operations before bridging will resume.