Cabletron Systems HSIM HSIM-G01 User Manual

Cabletron Systems HSIM HSIM-G01 User Manual Manual pdf 16 page image

Chapter 2: Installation2-2HSIM-G01/G09 User’s Guide2.2 INSTALLING AN HSIM-GYou can install an HSIM-G in any Cabletron Systems device that supportsHSIM technology (e.g., 2E42-27, 6E132-25).The following sections provide instructions for installing an HSIM-G inan interface module or in a standalone device. Refer to your specificinterface module or standalone device documentation for exact HSIM slotand connector locations. Refer to Section 2.2.1 to install the HSIM-G inan interface module, and Section 2.2.2 to install the HSIM-G in astandalone device.2.2.1 Installing an HSIM-G in an Interface ModuleTo install an HSIM-G in an interface module that supports HSIMtechnology, perform the following steps.1. Disconnect any network cables connected to the ports of the interfacemodule.2. Attach the antistatic wrist strap (refer to the instructions outlined onthe interface module User’s Guide).3. If the module is in a chassis, unlock the top and bottom plastic lockingtabs of the module faceplate, and remove the module from the chassis.4. Lay the module down with the internal components facing up.5. Refer to Figure 2-1 and remove the two faceplate mounting screwsand the HSIM coverplate. Save the screws.6. Refer to Figure 2-1 and remove the four standoff screws. Save thescrews.NOTERefer to the release notes for the version of firmware runningon the host platform to ensure that the HSIM-G is supported.“Host platform” is used to designate the interface module orstandalone device into which the HSIM-G is installed.TIPNote the ports of the interface module that have cablesattached to them. Write down the port numbers and label thecables to make it easier to reattach the network properly afterthe installation.