7Local Management: Overview, Setup, and NavigationTable 3 describes the most common event messages. Event messages related tospecific Local Management applications are described with those applicationsthroughout this manual.HeadingThe heading will indicate the module name, the same as listed next to ModuleType.Module Type and Slot NumberThese fields display only when a module is being accessed through LocalManagement. The module type is displayed and the chassis slot number of themodule is displayed. A chassis screen will not display these fields.Display FieldsDisplay fields cannot be edited. These fields may display information that neverchanges, or information that may change as a result of Local Managementoperations, user selections, or network monitoring information. In the screensshown in this guide, the characters in the display fields are in plain type (notbold). In the field description, the field is identified as being “read-only”.Input FieldsInput Fields require the entry of keyboard characters. IP addresses, subnet mask,default gateway and device time are examples of input fields. In the screensshown in this guide, the characters in the input fields are in bold type. In the fielddescription, the field is identified as being “modifiable”.Selection FieldsSelection fields provide a series of possible values. Only applicable values appearin a selection field. In the screens shown in this guide, the selections displaywithin brackets and are in bold type. In the field description, the field is identifiedas being either “selectable” when there are more than two possible values, or“toggle” when there are only two possible values.Table 3. Event MessagesMessage What It MeansSAVED OK One or more fields were modified, and saved toNVRAM.NOT SAVED?--PRESS SAVETO KEEP CHANGESAttempting to exit the LM Screen after one or morefields were modified, but not saved to NVRAM.NOTHING TO SAVE The SAVE command was executed, but no changeswere made that required saving.
