Cabletron Systems MicroMMAC-24E Installation Manual

Contents

Cabletron Systems MicroMMAC-24E Installation Manual Manual pdf 22 page image

Using the LCD and LCD DISPLAY ButtonMicroMMAC Installation GuidePage 2-32.3.1 Static System MessagesStatic System messages provide MicroMMAC configuration information.Table 2-1 lists each message. To view Static System messages, performthe following steps:1. Press and immediately release the Display button to view the firstStatic System Message in the queue.2. Press and release the Display button to display each subsequentmessage.If the Display button is not pressed again for ten seconds, the LCDdefaults to the product name.Table 2-1 Static System MessagesDisplayed Messages CommentsIP Addressxxx.xxx.xxx.xxxDisplays the MicroMMAC’s IP address. The IPaddress can be changed through LocalManagement.MAC Address00001dxxxxxxDisplays the MicroMMAC’s MAC address (thisaddress is also called the physical address).RAM ImageRev. xx.xx.xxDisplays the revision number of the imagecurrently executing in FLASH.Boot PROMRev. xx.xx.xxDisplays the revision number of the internalBoot PROM.Flash Programmedxx TimesDisplays the number of times FLASH has beenprogrammed.COM 1 PortBaud Rate xxxxxDisplays the Baud Rate for the COM 1 port. Thedefault setting is AUTO because theMicroMMAC uses Auto-Baud detection.COM 1 PortFunction xxxxxDisplays the current function of the COM 1 Port(N/A, UPS, LM).COM 2 Port Baud RatexxxxxDisplays the baud rate for the COM 2 port. Thedefault setting is AUTO because theMicroMMAC uses Auto-Baud detection.COM 2 PortFunction xxxxxxDisplays the current function of the COM 2 Port(N/A, UPS, LM).