Cabletron Systems MicroMMAC-24E Installation Manual

Contents

Cabletron Systems MicroMMAC-24E Installation Manual Manual pdf 23 page image

Chapter 2: Controls and IndicatorsPage 2-4MicroMMAC Installation Guide2.3.2 Saved Alarm MessagesSaved Alarm messages describe events that occur within theMicroMMAC or on the network. Table 2-2 shows each Saved Alarmmessage. To view Saved Alarm messages, perform the following steps:1. Press the Display button for five seconds and then release to view thefirst Saved Alarm message in the message queue.2. Press and immediately release the Display button to scroll througheach subsequent message.If the Display button is not pressed again for 10 seconds, the LCDdefaults to the product name.Table 2-2 Saved Alarm MessagesDisplayed Messages CommentsNo Messages in Queue No Alarm messages in queue. This is thedefault setting.Port xxxxxxSegmentedDisplays segmentation status of network ports1–24, EPIM-1 or EPIM-2.Port xxxxxxUnSegmentedDisplays segmentation status of network ports1–24, EPIM-1, or EPIM-2.Port xxxxxxLink EstablishedDisplays link status of network ports 1–24,EPIM-1, EPIM-2, or BRIM-1.Port xxxxxxNot LinkedDisplays link status of network ports 1–24,EPIM-1, EPIM-2, or BRIM-1.EPIM-xInsertedDisplays installation status of EPIM-1 orEPIM-2.EPIM-xRemovedDisplays installation status of EPIM-1 orEPIM-2.EPIM-xSecurity ViolationIndicates unauthorized access attempt atEPIM-1 or EPIM-2.CableRedun FailPort EPIM-xIndicates failure of redundant link at EPIM-1 orEPIM-2.CableRedun Enable Indicates redundant link enabled.Port EPIM-x EPIM-1 or EPIM-2.Port xxxxxxDisabledIndicates network ports 1–24, EPIM-1, orEPIM-2 disabled.