28 ELH100-12/24TX User Interface ELH100-12/24TXUser AccessOnce a direct connection to the serial port or a Telnet connection isestablished, the login screen for the on-board configuration programappears . You may need to press Enter a few times to display the screen.The default user names are “admin” and “guest,” with correspondingdefault passwords “admin” and “guest.” The administrator has Read/Writeaccess, which allows you to read and modify hub information. The guesthas Read Only access to the management program, which allows you toview hub information, but not modify any operating parameters.You should define a new administrator password, record it and put it in asafe place. From the Main Menu, select User Passwords and enter a newpassword for the administrator. Passwords can consist of up to 14alphanumeric characters and are not case sensitive.To use the console menus, do the following:1. Use the cursor keys to highlight the desired option.If the selected item is a submenu title, the submenu is displayedwhen you press the Enter key.2. Follow the screen prompts to specify the parameter requested.If the selected item is a parameter, the system displays a prompt forthe entry of a new parameter value. If the value entered is invalid, amessage displays, requesting you to enter a valid value.Factory DefaultsTable 3-1 lists the default settings for the hub configuration parameters.Each parameter can be changed via the console menus or Telnet.Table 3-1. Factory Default SettingsA user is allowed three attempts to enter the correctpassword; on the third failed attempt the currentconnection is terminated.Parameter Default ValueBootP Enable YesPort Enable YesScreen Timeout 10Send Modem Initialization String (ATQ0V0S0=1) YesSNMP Public Community Name publicTerminal Baud Rate 9600Terminal Hardware Flow Control No