30 ELS100-24TXM User Interface ELS100-24TXMSystem Configuration MenuThe System Configuration Menu enables modification of system-levelswitch configuration parameters. Select a from the Main Menu to view theSystem Configuration Menu. Figure 3-4 shows the System ConfigurationMenu and the accompanying table describes the System ConfigurationMenu.Figure 3-4. System Configuration MenuSYSTEM CONFIGURATION Access Control: READ/WRITEa. SNMP Configuration Menub System Namec. System Locationd. System Contacte. IP Address 000.000.000.000f. Subnet Mask 000.000.000.000g. Default Gateway 000.000.000.000h. BootP/DHCP Enable Yesi. Screen Timeout (minutes) 0j. Password Nonek. Terminal Baud Rate 9600l. Terminal Hardware Flow Control Nox. Previous MenuEnter Selection:Selection DescriptionSNMP Configuration Menu Menu for configuring SNMP-related parameters.System Name The switch administrative name (1-36 character range).System Location The physical switch location (1-36 character range).System Contact The switch contact person (1-36 character range).IP Address The IP address of the switch.Subnet Mask Subnet mask associated with the switch IP address.Default Gateway The default gateway (or router) to which the switch sendsIP packets destined for a different subnet.BootP/DHCP Enable Allows you to enable (Yes) or disable (No) the BootP andDHCP protocols for automatically configuring theswitch’s IP address information.Screen Timeout (minutes) The duration of time before a serial console or Telnetsession terminates due to user inactivity (0-65535 nu-meric range). A value of “0” means that the screen willnot terminate at any time.Password Allows “read/write” access to the user interface, via theserial console or Telnet (1-10 character range).Terminal Baud Rate Serial console baud rate (2400, 9600 or 19200).Terminal Hardware FlowControlAllows you to enable (Yes) or disable (No) hardware flowcontrol on serial console interface. Signals DTR, RTSand CTS are used for this purpose. Flow control shouldbe enabled if using external modem.
