Cadet RBF Owner's Manual

Also see for RBF101: Owner's manual Owner's manual

Contents

heater assembly

Cadet RBF Owner's Manual Manual pdf 4 page image

INSTALLATION INSTRUCTIONS (continued)RB/RBFWall CanHeater AssemblySpring ClipGrillGrill FrameGrill ScrewWasherHeater Assembly ScrewRocker SwitchSupplyWires_________ Retrofitting RBF101 as Replacement for RB Heaters _________Remove Existing HeaterSTEP 1A. WARNING! Before removing grill, turn the electrical power off at the electrical panel board (circuit breaker or fuse box). Lock or tagthe panel board door to prevent someone from accidentally turning the power on while you are working on the heater. Failure to do socould result in serious electrical shock, burns, or possible death.B. It is important that you verify power has been turned off and no power is going to the heater before proceeding. Circuit breakers areoften not marked correctly and turning the wrong breaker off could mean electricity is flowing to the heater, even if the heater does notappear to be working. If you are uncomfortable working with electrical appliances, unable to follow these guidelines, or do not have thenecessary equipment, consult a qualified electrician.C. Once you verify the power has been turned off correctly, proceed to next step.D. Remove screws and take off grill.E. Separate supply wire and lead wire connections.Proceed to PART TWO.__________________________ Part Two __________________________After you have followed all instructions in PART ONE or RETROFITTING, you are ready to install theheater assembly.STEP 1STEP 1How do I insert the heater assembly into the wall can?Install Heater AssemblySTEP 1Install Grill Frame and GrillSTEP 2Remove protective film from frame and grill before installing. Place grill frame outside top and bottom flanges of the heater assembly.Place grill over frame and secure with the four finishing washers and four #10 x 1½ inch Phillips oval head sheet metal screws (SeeFigure 4). Start all four screws before tightening (Note: Over tightening screws may damage grill).Install spring clips on wall can edge, two at the top and two at the bottom (See Figure 4). Lay heater assembly on its front surface andposition so rocker switch will be installed at bottom of wall can (See Figure 5). Make the connection of the supply wires to the lead wiresfrom the rocker switch. Position the heater assembly to fit adapter plate to the surface of the wall can (See Figure 4). Be sure all leadwires are inside the wall can before securing heater assembly. (Use the four #10 32 x ½ inch machine screws; two at top and two atbottom.)Figure 4Figure 5Page 4