Black plate (9,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010The cruise control buttons are located on left side of thesteering wheel.T (On/Off): Turns the system on or off. The indicatorlight is on when cruise control is on and turns off whencruise control is off.+ RES (Resume/Accelerate): Press to make thevehicle accelerate or resume to a previously set speed.SET − (Set/Coast): Press to set the speed or make thevehicle decelerate.[ (Cancel): Press to cancel cruise control withouterasing the set speed from memory.Setting Cruise ControlCruise control will not work if the parking brake is set,or if the master cylinder brake fluid level is low.The cruise control light on the instrument panel clustercomes on after the cruise control has been set to thedesired speed.{ WARNING:If you leave your cruise control on when you arenot using cruise, you might hit a button and gointo cruise when you do not want to. You could bestartled and even lose control. Keep the cruisecontrol switch off until you want to use cruisecontrol.1. Press the I button.2. Get up to the desired speed.3. Press the SET− button located on the steeringwheel and release it.4. Take your foot off the accelerator.Resuming a Set SpeedIf the cruise control is set at a desired speed and thenthe brakes are applied, this shuts off the cruise control.But it does not need to be reset.Once the vehicle speed reaches about 40 km/h(25 mph) or more, press the +RES button on thesteering wheel. The vehicle returns to the previously setspeed and stays there.4-9
