Cadillac Escalade Customization Manual

Also see for Escalade: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Cadillac Escalade Customization Manual Manual pdf 15 page image

13DriverInformation Safety &Security Comfort Performance &Maintenance OwnerPrivileges TMEntertainment ConvenienceStarting the VehicleTo remote start the vehicle:1. Aim the RKE transmitter at thevehicle.2. Press and release the (Lock)button on the transmitter.3. Immediately press and hold the(Remote Vehicle Start) buttonfor about four seconds.4. When the vehicle starts, theparking lamps will light andremain on while the engine isrunning.5. Repeat these steps for a 10-minutetime extension.When you enter the vehicle after aremote start, the key must beinserted in the ignition and turned tothe Run position before driving.Canceling a Remote StartIf you wish to turn off the engineinstead of driving after a remotestart, perform one of the followingfunctions:• Press and hold the button untilthe parking lamps turn off.• Press and release the HazardWarning Flashers button inside thevehicle. Press the button again toturn off the flashers.• Turn the key in the ignition switchon and then off.• The engine will automatically stopwhen time expires.AUTO TURN SIGNALThe turn signal lever includes anautomatic lane change signal feature.To signal a lane change, raise orlower the lever until the arrow on theinstrument panel cluster starts toflash, and then release the lever. Theturn signal will automatically flashthree times. If the Tow/Haul modeis selected, the turn signal willautomatically flash six times.To signal a turn, move the lever allthe way up or down.INTELLIBEAM AUTOMATICHEADLAMPS (if equipped)IntelliBeam uses a digital light sensorbehind the inside rearview mirror tomaximize forward night vision. Thesystem automatically switches on thehigh-beam headlamps when no othervehicle traffic is present, and switchesto low beam intensity when theheadlamps or taillamps of othervehicles are detected. The systemoperates only when driving over20 mph.The system is turned onautomatically when the headlampsystem is set to AUTO and the turnsignal/multifunction lever is in thelow beam position.To turn off the system, pressand hold the (AutoHeadlamps) button on the insiderearview mirror for three seconds.Press the button again to turn thesystem back on.Note: The Remote Vehicle Start featurewill not operate if the key is in theignition, a door or the hood is open, orthe Check Engine light is illuminated onthe instrument panel cluster.Escalade 2007 B 1/11/07 12:17 PM Page 15