Black plate (6,1)Cadillac SRX Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-6081464) - 2014 - CRC - 10/4/135-6 Instruments and ControlsThe wiper operations return tonormal when the transmission is nolonger in N (Neutral) or the vehiclespeed has increased.Reverse Gear WipesIf the rear wiper control is off, therear wiper will automatically operatecontinuously when the shift lever isin R (Reverse), and the frontwindshield wiper is performing lowor high speed wipes. If the rearwiper control is off, the shift lever isin R (Reverse), and the frontwindshield wiper is performinginterval wipes, then the rear wiperautomatically performs intervalwipes.This feature can be changed. SeeVehicle Personalization onpage 5-40.The windshield washer reservoir isused for the windshield and the rearwindow. Check the fluid level in thereservoir if either washer is notworking. See Washer Fluid onpage 10-19.Headlamp WasherIf equipped with headlamp washers,they are located to the side of theheadlamps.The headlamps must be on in orderto use the headlamp washers. If theheadlamps are not on, only thewindshield will be washed.Pull the wiper lever toward you andhold briefly to activate. Theheadlamp washers will spray once,pause, and spray again. Theheadlamp washer will spray againafter five windshield wash cycles.To refill the windshield washer fluid,see Washer Fluid on page 10-19.CompassThe vehicle may have a compassdisplay on the Driver InformationCenter (DIC). The compass receivesits heading and other informationfrom the Global PositioningSystem (GPS) antenna,StabiliTrak ® , and vehicle speedinformation.The compass system is designed tooperate for a certain number ofmiles or degrees of turn beforeneeding a signal from the GPSsatellites. When the compassdisplay shows CAL, drive thevehicle for a short distance in anopen area where it can receive aGPS signal. The compass systemwill automatically determine when aGPS signal is restored and providea heading again. See CompassMessages on page 5-30 for themessages that may be displayed forthe compass.ClockThe infotainment system controlsare used to access the time anddate settings through the menusystem. See “Home Page” in theinfotainment manual for informationabout how to use the menu system.