CalAmp Viper 100 User Manual

Contents

CalAmp Viper 100 User Manual Manual pdf 28 page image

#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 21 10 watt supply for Tx @ 1W 40 watt supply for Tx @ 5W, or 60 watt supply for Tx @ 10 WViper Demo Kits contain a power connector with screw-terminals. Observe proper polarity when connecting the cables tothe Power Supply. The white wire must be connected to red wire.3.4 CONNECT VIPER SC TO PROGRAMMING PCConnect a PC’s Ethernet port to the LAN port using a CAT 5 Ethernet cable. Wait for the LINK LED to glow green.3.5 CONFIGURE YOUR VIPERViper must be configured using the Setup Wizard. This quick start will use the Setup Wizard to configure your Viper forbridge mode operation.For other configuration options: Refer to Section 4.3 for Basic Setup Refer to Section 4.4 for Advanced Setup.3.5.1 INITIAL INSTALLATION LOGINOn your Internet browser address line, type the factory-default IP address: 192.168.205.1. Press Enter to open the NetworkPassword screen.For initial installation, enter a User Name and the default password. User Name: 1 to 15 characters Default Password: ADMINISTRATOR. Password is case sensitive. Click OK. The web interface WELCOME screen opens.