6 — M achinist calc™ / M achinist calc™ ProDimensional function Keysm Millimeters — Identifies entry as millimeters, withrepeated presses toggling between linear, area andvolume units. Converts dimensional value to units ofmillimeters, with repeated presses toggling betweenmillimeters and meters.g 5 Centimeters (cm) — Identifies entry ascentimeters, with repeated presses togglingbetween linear, area and volume units.g 9 Meters (m) — Identifies entry as meters, with repeat-ed presses toggling between linear, area and volumeunits.g 7 Feet — Identifies entry as Feet, with repeated press-es of g 7 toggling between linear, area and volumeunits. Also used with i and / for entering Feet-Inchvalues. Repeated presses of g 7 during conversionstoggle between fractional Feet-Inch and decimal Feet.i Inch — Identifies entry as Inches, with repeatedpresses toggling between linear, area and volumeunits. Entry can be whole or decimal numbers. Alsoused with / for entering fractional Inch values (e.g.,9i 1/2). Repeated presses during conversionstoggle between fractional and decimal Inches./ Fraction Bar — Used to enter fractions. Fractionscan be entered as proper (1/2, 1/8, 1/16) or improper(3/2, 9/8). If the denominator (bottom) is not entered,the calculator’s fractional accuracy setting isautomatically used. Results are always shown intypical dimensional fractional format.B 1/1000” (mils) — Multiplies a dimensionless entry by0.001 Inch and displays the result as Inches. Convertsa linear entry to decimal Inches. For both methods,the result is rounded and displayed to three decimalplaces.