INSTRUCTIONAL MANUAL 2750L-P/4500L-P/6000L-PAugust, 2001 Rev. K-80-The status contained in "message" may be any of the following for non-CNF messages:SYNTAX ERRORVOLT RANGE ERRORFREQ RANGE ERRORCURL RANGE ERRORPANG RANGE ERRORThe response of the power source under a short circuit condition is as follows:F07ACS01(DEV): OUTPUT CH01&02&03 VOLT FAULT A setup string can always be followed by another string with the STA OP-code. In the event of a syntax, range orsystem error, an error message will be returned to the bus controller when the power source is addressed to talk. Thevalue of the last parameter in a setup string is the one displayed on the front panel of the power source.3.8.7 DISCRETE FAULT INTERRUPTA discrete fault condition is one that would pose a hazard to equipment or personnel. A Discrete Fault Interrupt (DFI) issupplied with the MT power source option. The DFI relay contacts are connected to the BNC connector, J3, on thepower source rear panel. Under normal operating conditions, the DFI relay contacts are open; when a fault is detected,the contacts close. The user may connect any type of indicator or alarm circuit to the DFI connector provided theapplied signal is limited to 0.1 amps and 26 volts.The conditions which will cause the discrete fault interrupt are listed in Table 3-18.Table 3-18 DISCRETE FAULT INTERRUPT CONDITIONSFAULT CONDITIONOVERLOAD OUTPUTPROGRAMMABLE CURRENTOVERTEMPERATURECONTROLLER FAILUREPOWER OFFThe full rated power capability is exceed on any phase where programmedoutput voltage is not maintained.The load draws more current than the programmed current limit point onany phase.Excess heatsink temperature in power supply or output amplifier due tohigh ambient temperature or internal component failure.The AC Power Controller has a CPU failure which is monitored by a watchdog timer.Power remains off - input breaker off.