INSTALL HANDLE1. Install the handle as shown in Fig 3.2. Tighten all hardware.INSTALL SHELF1. Install shelf as shown in Fig 4.2. Tighten all hardware.GREASE BUCKET1. Hang grease bucket from tube as shown in Fig 4.ASH CUP1. Install Ash Cup as shown in Fig 5. Never use grill without Ash Cup in place.M6 X 15 SCREWM6 X 15 SCREWGREASE BUCKETASH CUPM6 X 15 SCREWM6 NUTM6 FLAT WASHERM6 LOCK WASHERCHIMNEY GASKETM6 NUTM6 X 76 BOLTM8 X 45 BOLTM8 FLAT WASHERM8 LOCK WASHERM8 NUTASSEMBLY INSTRUCTIONSATTACH THE LEGS1. Lay the grill on its back.2. Install each of the 4 legs as shown in Fig 1. Make sure the legs with wheels are attached to the right side of the grillwith the wheels facing out.3. Stand the grill upright4. Tighten all hardware.ATTACH CHIMNEY AND CHIMNEY CAP1. Install chimney to grill as shown in Fig 2. Make sure to install the gasket between the grill and the chimney.2. Tighten all hardware.3. Install M6 x 76 Bolt through chimney cap and secure using Qty (1) M6 nut. Thread second nut onto bolt leavingapproximately 1.5” to the top of the cap. Thread cap assembly down into the chimney bracket until the lower nut hitsthe bracket. See Fig 2.4. The height of the chimney cap can be adjusted for summer and winter. In the summer the gap should be approximately1-1/2”. In the summer the gap should be approximately ½”.5. Tighten all hardware.Fig. 1Fig. 2Fig. 3Fig. 4Fig. 5