Cannon CAMBERLEY Mk3 Use And Installation Instructions

Contents

30Prior to installation, ensure that the local distribution conditions (nature of the gas andgas pressure) and the adjustment conditions are compatible. The adjustmentconditions for this appliance are stated on the data badge which is fitted below theoven door.This appliance is not designed to be connected to a combustion products evacuationdevice. It must be installed and connected in accordance with current installationregulations. particular attention should be given to the relevant requirementsregarding ventilation.MODEL NUMBERS 10300G Mk3, 10305G Mk3 AND 10308G Mk3Category I2H (GB. IE)These models are set to burn NATURAL GAS (G20) at 20 mbar ONLY and can not beused on any other gas.GAS SAFETY (INSTALLATION & USE) REGULATIONSIt is the law that all gas appliances are installed by competent persons inaccordance with the current edition of the above regulations. It is in your interest andthat of safety to ensure compliance with the law.In the UK, CORGI registered installers work to safe standards of practice.The cooker must also be installed in accordance with BS 6172: 1990.Failure to install the cooker correctly could invalidate the warranty liability claims andcould lead to prosecution.LOCATIONThe cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not ina room containing a bath or shower. The cooker must not be installed in a bed-sittingroom of less than 20m 3.PROVISION FOR VENTILATIONThe room containing the cooker should have an air supply in accordance withBS 5440: Part 2: 1989.The room must have an opening window or equivalent; some rooms may also requirea permanent vent. If the room has a volume between 5 and 10m 3, it will require an airvent of 50cm 2 effective area unless it has a door which opens directly to outside. If theroom has a volume of less than 5m 3, it will require an air vent of 100cm 2 effective area.If there are other fuel burning appliances in the same room, BS 5440: Part 2: 1989should be consulted to determine air vent requirements.INSTALLATION INSTRUCTIONS