35ELECTRICAL CONNECTIONWARNING – THIS APPLIANCE MUST BE EARTHED.CONNECT TO A 230-240V A.C. SUPPLY ONLY.Connection to the electricity supply should be made via a properly earthed, readily accessiblewall socket which is adjacent to but not directly above, and not more than 1.25m away from theappliance and capable of electrical isolation.Should this plug not fit the socket outlet in your home it should be cut off and replaced with asuitable plug as outlined below.NOTE: The removed plug cannot be used for any other appliance and should therefore beproperly disposed of and not left where children might find it and plug it into a supply socket –with the obvious consequent danger.IF THE FITTED PLUG IS REMOVEDThe flexible mains lead must be correctly connected as below to a three pin plug of not lessthan 13 amp capacity. If a B.S. 1363 fused plug is used, it must be fitted with a 3 amp fuse whichis approved to B.S. 1362.IMPORTANT: The wires in the mains lead fitted to this appliance are coloured in accordancewith the following code:GREEN AND YELLOW – EARTHBLUE – NEUTRALBROWN – LIVEAs the colours of the wires in the mains lead of this appliance may not correspond with thecoloured markings identifying the terminals in your plug, proceed as follows:– The wire which iscoloured green and yellow must be connected to the terminal in the plug which is marked withthe letter E or by the earth symbol or coloured green or green and yellow. The wire which iscoloured blue must be connected to the terminal which is marked with the N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with theletter L or coloured red. When wiring the plug, ensure that all strands of wire are securelyretained in each terminal. Do not forget to tighten the mains lead clamp on the plug. As theappliance must be earthed, do not use 2-pinsockets outlets, if you are in doubt, consult a qualified electrician.Should the mains lead ever require replacement, it is essential that this operation be carried outby a qualified electrician and should only be replaced with a flexible cord of the same size i.e.0.75mm 2 cross sectional area.IF A MOULDED PLUG IS FITTEDIn the event of replacing a fuse in the plug supplied a 3 amp ASTA approved fuse to BS1362must be fitted.NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing the fusecover the plug must not be used until a replacement fuse cover has been obtained and fitted. Anew fuse cover can be obtained from your local Electricity Board. The colour of the correctreplacement fuse cover is that of the coloured marks or inserts in the base of the plug.Make sure that the cable does not become trapped when pushing the cooker into position.Green &Yellow toEarthBrown toLiveBlue toNeutralCord Clamp3 AmpFuse