Cannon Canterbury CANTIB-SDEEB Instruction Manual

Contents

Cannon Canterbury CANTIB-SDEEB Instruction Manual Manual pdf 15 page image

Cannon Fitzroy / Canterbury Inbuilt | 15log installation1. The burner is contained within the burner chamber.refer FIG 17.2. Carefully unpack the log set. logs are numberedas follows:#1 - left front log#2 - left back log#3 - right front log#4 - right back logPosition the four individually numbered logs in thefollowing order on the burner bed as shown inFIG 18-21. The locating pins on burner bed must engagewith corresponding holes in the individual logs.a) Place log #1 into the 2 front left pins on the burner bed,ensuring that the charring faces the front.refer FIG 18.b) Place log #2 onto the 2 left back pins. refer FIG 19.c) Place log #3 on single right front pin, ensure forklocates over log #2. refer FIG 20.d) Place log #4 on single right back pin, ensure left sideof log rests on depression in #3 log. refer FIG 21.3. refit the inner glass, making sure not to overtighten the screws.4. reconnect switch loom to the fascia switch set.5. refit the front fascia.gas ConneCtionfig 18 fig 19fig 21fig 201. Push the gas inlet access plate into the heater cabinetand slide the heater into the fireplace ensuring that thegas inlet pipe is fed through the hole located at the rearright hand side of the heater at the bottom.refer FIG 22.2. With heater in position, flanges should be hard againstmasonry. Secure case flanges to the masonry.Screw or bolt the flange through the slots provided.Note: The appliance must be secured at the front toa vertical face. Where this is difficult due to buildinginaccuracies, limited non-combustible packing may beused to obtain a suitable vertical surface. Method offixing to finished wall surface (plaster/masonary/brick)suitable fixtures which are able to be easily removedmust be used.3. Connect the gas supply pipe to the coppercompression fitting provided (we recommend usinga basin wrench). Push the gas inlet plate down to itsoriginal position and seal with an appropriate easilyremovable material. Do not seal with a silicone sealantas the heater must be easily removable. Sealing isimportant as it prevents any leakage of flue productsinto the room. Test all connections for gas leaks.fig 17Burner in base ofburner chamber69 mm35 mm69 mm35 mmfig 23fitzroy Canterbury fig 24fig 22gas Inlet1/2 inch compressionSolid copperpipe to beused only4. Heater is not to be connected using a flexible hose.