Recording301 Move the power switch to ON to setthe camcorder in CAMERA mode.The red CAMERA indicator will turnon.2 Move the / switch to the(Still images) position.3 If necessary, change the media forrecording the still images.Refer to Selecting the Media for theStill Images ( 30).4 Press halfway.• Once the focus is automaticallyadjusted, will turn green and one ormore AF frames appear.• When you presson the wireless controller, thestill image is recorded immediately.5 Press fully.The CARD access or DISC accessindicator will flash as the image isbeing recorded.IMPORTANTAvoid the following actions while the disc/cardaccess display ( or ) appears onscreen, and when either the DISC access orCARD access indicator is on or flashing. Failingto do so may result in permanent data loss.- Do not subject the camcorder to vibrations orstrong impacts.- Do not open the disc cover or the memorycard slot cover and do not remove the disc ormemory card.- Do not disconnect the power source or turn offthe camcorder.- Do not change the position of the /switch or the operating mode.NOTESIf the subject is not suitable for autofocus,turns yellow. Keep pressed halfwayand adjust the focus manually with the multiselector ( ).Selecting the Media for the Still ImagesYou can record still images on thememory card or the disc. The defaultmedia for still images is the memory card.As long as you do not change therecording destination, still images will berecorded on the last selected media.1 Press .2 Select ( ) [SYSTEM SETUP] andpress ( ).3 Select ( ) [MEDIA SEL. ] andpress ( ).4 Select ( ) [DISC] or [CARD] andpress ( ) to save the setting andclose the menu.When recording, the operating modesymbol will change to (DISC stills) or(CARD stills), depending on themedia selected. In playback mode, theoperating mode symbol will change to(DISC stills) or (CARD stills),respectively.PHOTOPHOTOPHOTO( 11)MENU( 24)PHOTOMENU
