Canon DR-5060F Instructions Manual

Also see for 5060F - Document Scanner: Instructions

Contents

79Setting Detailed Scan Conditions3[Y Offset Start]Enter the scanning start point on the Y-axis (vertical direction) referenced to theleading edge of the original in the feed direction in millimeters (mm).[Y Offset End]Enter the scanning end point on the Y-axis in millimeters (mm).MEMOl Be sure to enter both [X Offset End] and [Y Offset End] when specifying thescan area. Otherwise a parameter error will occur.l The orientation and position of function sheet patterns is determined asfollows. Pay attention to this when specifying the scan area to prevent scanerrors from occurring.10 mm (0.39 in.)51 mm (2.0 in.)10 mm (0.39 in.)29.25 mm (1.14 in.)u OrientationSpecify the orientation of the patch code in the original.[Horizontal]Scans patch codes in the horizontal direction.[Vertical (90)]Scan patch codes that are rotated 90 degrees to the right.[Vertical (270)]Scan patch codes that are rotated 90 degrees to the left.MEMOWhen the orientation of patch codes is set inverted, FILE A patch codeperforms the same action as that of FILE B. Note, however, that if FILE B patchcodes are inverted, FILE B is not detected as a patch code.Paper center lineSetting Scan Conditions