Canon E410 Series Online Manual

Also see for PIXMA E414: Online manual

Regulatory InformationUsers in the U.S.A.FCC Notice (U.S.A. Only)For 120V, 60Hz modelModel Number: K10392This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TV technician for help.Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the manual. Ifsuch changes or modifications should be made, you could be required to stop operation of the equipment.Canon U.S.A., Inc.One Canon ParkMelville, New York 117471-800-652-2666Environmental InformationReducing your environmental impactPower Consumption and Operational ModesThe amount of electricity a device consumes depends on the way the device is used. This product isdesigned and set in a way to allow you to reduce the power consumption. After the last print it switchesto Ready Mode. In this mode it can print again immediately if required. If the product is not used for atime, the device switches to its Sleep Mode. The devices consume less power (Watt) in these modes.63