471 Using Full Auto5 Take the picture.Compose the shot and press theshutter button completely.X The captured image will be displayedfor about 2 sec. on the LCD monitor.To view the images captured so far,press the <x> button. (p.113)While focusing with <AF>, do not touch the focusing ring at the front of the lens.If you want to zoom, do it before focusing. Turning the zoom ring afterachieving focus may throw off the focus.When the CF card becomes full, the CF Full warning “FuLL CF” willappear in the viewfinder and on the LCD panel and shooting will bedisabled. Replace the CF card with one that has room.Be careful not to obstruct the built-in flash from popping up. If “Err 05” isdisplayed, set the <4> switch to <2> and <1> again.Using a non-Canon lens with an EOS camera may not result in propercamera or lens operation.When focus is achieved, the focus and exposure setting will also be locked.If the focus confirmation light <o> blinks, the picture cannot be taken. (p.80)Multiple AF points may flash simultaneously in red. This indicates thatfocus has been achieved at all those AF points.In the Basic Zone modes (except <3> <5> <7>), the built-in flashwill pop up and fire automatically in low-light or backlit conditions. Toretract the flash, push it back down.In the Basic Zone modes, the Picture Style (p.56) will be set automatically forthe respective Basic Zone mode. To find out which Picture Style is set for theBasic Zone mode, see the “Function Availability Table” on page 176.You can disable the beeper from sounding when focus is achieved. Setthe [z Beep] menu item. (p.100)The image review time after image capture can be changed with themenu’s [x Review time] setting. (p.110)If you want to select the AF point to be used for focusing, set the Mode Dialto <d>, then follow “Selecting the AF Point” (p.77) to select the AF point.
