89Single and continuous drive modes are provided. In the Basic Zonemodes, the optimum drive mode is set automatically.1 Press the <o> button. (9)2 Select the drive mode.While looking at the LCD panel, turnthe <5> dial.u : Single shootingWhen you press the shutter button completely, one shot will betaken.o: High-speed continuous shooting (Max. 6.3 shots per sec.)i : Low-speed continuous shooting (Max. 3 shots per sec.)In the o and i modes, the camera will shoot continuouslywhile you hold down the shutter button completely.j : Self-timer (10-sec. delay)l : Self-timer (2-sec. delay)See the next page for the self-timer operation procedure.i Selecting the Drive ModeNWhen the internal buffer memory becomesfull during continuous shooting, “buSY” willbe displayed on the LCD panel and in theviewfinder and shooting will be disabledtemporarily. As the captured images are recorded to the card, you will beable to shoot more images. Press the shutter button halfway to check inthe viewfinder’s bottom right for the current maximum burst. This is themaximum number of shots that can be taken continuously.If “FuLL CF” is displayed in the viewfinder and on the LCD panel, waituntil the access lamp stops blinking, then replace the card.When the battery level is low, the continuous shooting speed will beslightly slower.In the AI Servo AF mode, the continuous shooting speed may becomeslightly slower depending on the subject and the lens used.Maximum burstCOPY
