4-612345Cover/Table ofContentsDownloading Imagesfrom the Camera,and Camera SettingsWorking withImages in theZoomBrowser EXRemote Shooting inthe EOS CaptureTroubleshootingand Uninstallingthe SoftwareIndexSetting the EOS 5Dand EOS-1D SeriesCamerasIntroductionRetains the shift amount for program shiftO Normally, any program shift amount is canceled after you take the picture. This PersonalFunction retains the program shift amount.O This function is useful when you want to shift the standard program line so that priority isgiven to the shutter speed or to the aperture.By shifting the program, you can change the shutter speed or aperture and still retain the sameexposure level. Under the same brightness, you can shift the program line toward the right toset a faster shutter speed and a larger aperture (lower f/number). Or you can shift the programline toward the left to set a slower shutter speed and a smaller aperture (higher f/number).P.Fn-10 retains the amount of program shift. Select the appropriate amount of shift for the levelof priority you want to give to the shutter speed or aperture setting.Executes AI Servo AF continuous shooting giving priority tothe drive speedO During continuous shooting, shutter release-priority takes effect instead of focus-priority.O Effective when it is more important to capture an image even though it might be slightly outof focus.O This function is compatible with the EOS-1D only.O The program shift amount remains in effect until you set it back to the standard programmanually or replace the battery or press the button.O The shift amount is retained even after you change the lens.P.Fn-1010-1-2-3-4-53222161185.642.82000100030 158421248 15 30 60 125 2501.01.429 10 11 12 13 14 15 16 17 18 19 20 215005 6 78432232280004000Darker Brightness (EV at ISO100) BrighterApertureStandard program lineProgram line shifted toward a faster shutter speed.Program line shifted toward a slower shutter speed.With EF50mm f/1.4 USM Shutter SpeedP.Fn-13Disables focus detection (search driving) by the lens driveO Normally, when you press the shutter button halfway and focus cannot be achieved, the lensis driven to search the correct focus. This lens driving operation can be turned off.O When focus has been achieved once and refocusing fails, the subsequent lens drivingoperation can result in grossly out of focus. This subsequent lens driving operation is turnedoff. P.Fn-14 is especially suited for super telephoto lenses.Disables the AF-assist beam from being emittedO This disables the external Speedlite’s built-in AF-assist beam.O At a joint photo session, etc., this prevents the AF-assist beam’s pattern projected on thesubject from being photographed by other photographers.Enables automatic shooting when focus is achieved at thefixed point of focus while the shutter button is pressed fullyO This takes the picture automatically when the subject comes to the preset focusing distance.Focusing detection is performed using the selected AF point.O Set the lens focus mode switch to and focus manually at the desired point of focus.O Keep pressing the shutter button fully.O Using an accessory such as Remote Controller RS-80N3 which can lock the shutter buttonrelieves you from holding down the shutter button while you wait for the subject.If autofocusing is attempted while the lens is way out of focus, the lens may stopoperating. Focus manually until the subject outline becomes discernable, thenautofocus.O Because the camera remains on standby while the shutter button is fully pressed,battery power is used up more quickly. For long periods of photography, use the DCCoupler Kit.O When this function is used in combination with a flash, the flash remains on standbyat full charge. Consequently, the flash batteries are used up more quickly. (TheSpeedlite’s SE mode is disabled.)O When you use a flash with this function, set the drive mode to single-frame shooting.If you select continuous shooting, the flash will be unable to charge in time forsuccessive shots and will not fire at full charge.O If you set the drive mode to continuous shooting, set the number of shots in P.Fn-20.If you do not use P.Fn-20, once the camera focuses on the subject, continuousshooting will continue until the capacity of the memory card is reached.O P.Fn-16 cannot be used with manual focus lenses or with lenses that are too slow tobe used with autofocusing.O Do not use this function when C.Fn-4-1/3 is set as shots will be taken regardless ofwhether the image is in focus.Using an accessory such as Remote Controller RS-80N3 which can lock the shutterbutton is recommended.P.Fn-14P.Fn-15P.Fn-16