203If there is a problem, first refer to this Troubleshooting Guide. If thisTroubleshooting Guide does not resolve the problem, contact yourdealer or nearest Canon Service Center.Do not recharge any battery pack other than genuine Canon BatteryPack LP-E6.If there is a problem with the battery charger or battery pack or ifcommunication with the battery pack (non-Canon battery packs) is notpossible, the protective circuit will terminate the charging and theorange lamp will blink quickly at a regular interval. If there is a problemwith the battery charger or battery pack, unplug the charger’s powerplug from the power outlet. Detach and reattach the battery pack to thecharger. Wait 2 to 3 minutes, then reconnect the power plug to thepower outlet. If the problem persists, contact your dealer or nearestCanon Service Center.If the internal temperature of the battery pack attached to the chargeris high, the charger will not charge the battery for safety reasons (lampoff). During the charging, if the battery’s temperature becomes high forany reason, the charging will stop automatically (lamp blinks).Whenthe battery temperature goes down, the charging will resumeautomatically.The battery is not properly installed in the camera (p.26).Recharge the battery (p.24).Make sure the battery compartment cover is closed (p.26).Make sure the card slot cover is closed (p.29).Troubleshooting GuidePower-Related ProblemsThe battery cannot be recharged with the battery charger provided.The charger’s lamp blinks at high speed.The charger’s lamp does not blink.The camera does not operate even when the power switch is set to <1>.COPYDownloaded From camera-usermanual.com Canon Manuals
