471If a problem occurs with the camera, first consult this TroubleshootingGuide. If this Troubleshooting Guide does not resolve the problem,contact your dealer or nearest Canon Service Center.If the battery’s remaining capacity is 94% or higher, the battery will notbe recharged (p.446).Do not use any battery other than genuine Battery Pack LP-E6N/LP-E6.If (1) the battery charger or battery has a problem or (2) communicationwith the battery failed (with a non-Canon battery pack), the protectioncircuit will stop charging, and the charge lamp will blink in orange at ahigh speed. In the case of (1), unplug the charger’s power plug from thepower outlet. Detach and reattach the battery to the charger. Wait a fewminutes, then reconnect the power plug to the power outlet. If theproblem persists, contact your dealer or nearest Canon Service Center.If the internal temperature of the battery attached to the charger ishigh, the charger will not charge the battery for safety reasons (lampoff). During charging, if the battery’s temperature becomes high forany reason, charging will stop automatically (lamp blinks). When thebattery temperature goes down, charging will resume automatically.Make sure the battery compartment cover is closed (p.42 ).Make sure the battery is installed properly in the camera (p.42).Recharge the battery (p.40).Make sure the card slot cover is closed (p. 43).Troubleshooting GuidePower-Related ProblemsThe battery does not recharge.The charger’s lamp blinks at high speed.The charger’s lamp does not blink.The camera does not operate even when the power switch is set to <1>.
