452If a problem occurs with the camera, first consult this TroubleshootingGuide. If this Troubleshooting Guide does not resolve the problem,contact your dealer or nearest Canon Service Center. Do not use any battery other than genuine Canon Battery PackLP-E17. If (1) the battery charger or battery has a problem or (2)communication with the battery failed (with a non-Canon battery pack),the protection circuit will stop charging, and the charge lamp will blinkin orange. In the case of (1), unplug the charger’s power plug from thepower outlet. Detach and reattach the battery to the charger. Wait twoor three minutes, then reconnect the power plug to the power outlet. Ifthe problem persists, contact your dealer or nearest Canon ServiceCenter. Make sure the battery is installed properly in the camera (p.40). Make sure the battery compartment cover is closed (p.40). Make sure the card slot cover is closed (p.41). Recharge the battery (p.38). Press the <B> button (p.76). If the power is turned off while an image is being recorded to the card,the access lamp will remain on or continue to blink for a few seconds.When the image recording is complete, the power will turn offautomatically.Troubleshooting GuidePower-Related ProblemsThe battery does not recharge.The battery charger’s lamp blinks.The camera is not activated even whenthe power switch is set to <1>.The access lamp still blinks even whenthe power switch is <2>.
