xxiiiWhat Can I Do with This Machine?Users in the U.S.A.Pre-Installation Requirements for Canon Facsimile EquipmentA. LocationSupply a suitable table, cabinet, or desk. See p. 10-2 for the machine’s weight and dimensions.B. Order Information1. Only a single line, touch-tone or rotary telephone set is to be used.2. Order an RJ11-C modular jack (USOC code), which should be installed by the telephonecompany. If the RJ11-C jack is not present, installation cannot occur.3. Order a regular voice grade line or the equivalent from your telephone company’s businessrepresentative.Use one line per machine.DDD (DIRECT DISTANCE DIAL) LINE-or-IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEASCanon recommends an individual line following industry standards, e.g. the 2500 (Touch Tone) or 500(Rotary/Pulse Dial) telephones. A dedicated extension off a PBX machine without “Call Waiting” can beused with the machine. Key telephone systems are not recommended because they send non-standardsignals to individual telephones for ringing and special codes, which may cause a fax error. This machineis not supported on Voice Over Internet Protocol (VOIP).C. Power RequirementsThis equipment should be connected to a standard 120-volt AC, three-wire grounded outletonly. Do not connect this machine to an outlet or power line shared with other appliances thatcause “electrical noise.” Air conditioners, electric typewriters, copiers, and machines of thissort generate electrical noise which often interferes with communications equipment and thesending and receiving of documents.
