Canon Image Prograf PRO-2000 Setup Manual

4• Models That Use the Roll UnitAttach the roll unit to the stand.-> Refer to the Roll Unit Setup Guide (separate manual).• Models That Do Not Use the Roll UnitProceed to "Attach the Basket".• Models That Use a StandAttach the basket to the stand.-> Refer to "Attach the Basket" in the Printer Stand Setup Guide (separate manual).• Models That Do Not Use a StandProceed to "Turn On the Printer".4 Place the printer on the stand such that the protrusion (A) for aligningthe position of the printer under the rear side of the printer is alignedwith the position of the black marker on the basket rod attached tothe supporting plate.A AImportant• If you are not using a stand, place the printer in the installationlocation and proceed to "Turn On the Printer".5 Affix the printer to the stand.Remove the basket rod.Use an M4 Allen wrench to securely affix three M4 hex screwseach on the left and right from the bottom of the supporting plate.1 Open the top cover.2 Pull up and remove the belt stopper (A).ANote• Keep the belt stopper you removed for future use. Youwill need them in case you move the printer to anotherlocation.• When you open the top cover, a cleaning brush isstored on the right side. Take it out and use it whencleaning inside the top cover.Attach the BasketTurn On the PrinterAttach the Roll Unit