Expand Serial Command Specification Page 15 of 468.4.4. CF_TINT CommandCommand “CF_TINT_%1” [CR]%1“000 ~ 063” -------------- Directly select the Tint setting value“UP” ----------------------- Tint setting value +1“DN” ------------------------ Tint setting value -1DetailsSet the User control Tint value.The value set by their Command will not be saved to the Projector.Therefore, when All Off the Projector, the value will return to the originalsetting. (For Stand-by mode, this value stays.)Only valid when it is in the usual Power On state.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.5. CF_SHARP CommandCommand “CF_SHARP_%1” [CR]%1“000 ~ 031” -------------- Directly select the Sharpness setting value“UP” ----------------------- Sharpness setting value +1“DN” ------------------------ Sharpness setting value -1DetailsSet the User control Sharpness value.The value set by their Command will not be saved to the Projector.Therefore, when All Off the Projector, the value will return to the originalsetting. (For Stand-by mode, this value stays.)Only valid when it is in the usual Power On state.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.6. CF_GAMMA CommandCommand “CF_GAMMA_%1” [CR]%1“000 ~ 015” -------------- Directly select the Gamma setting value“UP” ----------------------- Gamma setting value +1“DN” ------------------------ Gamma setting value -1DetailsSet the User control Gamma value.The value set by their Command will not be saved to the Projector.Therefore, when All Off the Projector, the value will return to the originalsetting. (For Stand-by mode, this value stays.)Only valid when it is in the usual Power On state.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]