Canon Laser Class 700 Series Setup Manual

Also see for Laser Class 700 Series: Facsimile guide Specification Datasheet Network guide Reference guide

Canon Laser Class 700 Series Setup Manual Manual pdf 9 page image

viiiLegal NoticesFCC (Federal Communications Commission)This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.• Consult your local authorized Canon dealer or an experienced radio/TV technicianfor help.Do not make any changes or modifications to the equipment unless otherwisespecified in the manual. If such changes or modifications should be made, youcould be required to stop operation of the equipment.Laser SafetyThis product complies with 21 CFR Chapter 1 Subchapter J as a Class Ι laserproduct under the U.S. Department of Health and Human Services (DHHS)Radiation Performance Standard according to the Radiation Control for Health andSafety Act of 1968. Class Ι levels of laser radiation are not considered to behazardous.Since radiation emitted inside the product is completely confined within protectivehousings and external covers, the laser beam cannot escape from the machineduring any phase of user operation. Do not remove protective housings or externalcovers, except as directed by the equipment's Reference Guide.