Quick Start Function44Quick Start FunctionWhen you close the LCD panel with the camcorder on, the camcorder enters the standby mode. Instandby mode the camcorder consumes only about 1/3 the power used when recording, savingenergy when you are using a battery pack. Additionally, when you open the LCD panel or pull out theviewfinder, the camcorder is ready to start recording in approximately 1 second*, allowing you torecord the subject right away.* The actual time required varies depending on the shooting conditions.1 With the camcorder on and in a recording mode, close the LCD panel.• A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate thecamcorder entered standby mode.• When using only the viewfinder (with the LCD panel closed), you can return the viewfinder to itsretracted position to set the camcorder in standby mode.2 When you wish to resume recording, open the LCD panel.• The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record.• You can also pull out the viewfinder to start recording with the LCD panel closed.IMPORTANT• Do not disconnect the power source during standby mode (while the ON/OFF (CHG) indicator is litin orange).NOTES• The camcorder will not enter standby mode while the ACCESS indicator is on or flashing, while thesetup menus are being displayed or while using the viewfinder. The camcorder may also not enterstandby mode when the battery charge is too low. Check that the ON/OFF (CHG) indicator changesto orange.• About standby mode and auto power off:- The camcorder will power off automatically if left in standby mode for 10 minutes. Press Pto turn on the camcorder.- You can select the length of time until auto power off or turn off the Quick Start functionaltogether with the q > [Power Saving Mode] > [Quick Start (Standby)] setting.- The usual 5-minute auto power off setting of [Power Saving Mode] is not applicable while thecamcorder is in standby mode.• Changing the position of the mode switch while the camcorder is in standby mode will reactivate thecamcorder in the operating mode selected.Operating modes:COPYDownloaded From VideoCamera-Manual.com Manuals
