50EUsing the FullRange of FeaturesIf your wireless controller isn’t working:Make sure the camcorder and the wireless controller are both set to the samemode. Check the mode the camcorder is set to by pushing any button other thanthe REMOTE SET button on the wireless controller. The camcorder’s modeappears in purple for about 4 seconds. Set the wireless controller’s modeaccordingly by pressing the aforementioned button combinations. If the wirelesscontroller still doesn’t work, change the batteries.Notes:• The mode the camcorder is set to also appears for 4 seconds when you turn thepower on.• When you replace the batteries, the wireless controller returns to mode 1.Change the mode again if necessary.Turning off the tally lampTo turn the tally lamp off, open the menu and select SYSTEM. Thenselect TALLY LAMP, set it to OFF and close the menu.• The tally lamp no longer flashes during recording, but it will still light upwhen the camera receives a signal from the wireless controller and duringthe self-timer countdown.TALLY LAMP••ONSYSTEM( 39)The tally lamp lets you know that thecamera is recording, receiving signalsfrom the wireless controller orcounting down for the self-timer.However, its flashing may be reflectedinto the lens during close-up recording,or when recording through glass.You may therefore decide to turn it off.CAMERA PLAY (VCR) CARD CAMERAMV5i MCCARD PLAY (VCR)MV5i MC
