List of MessagesMessage Explanation Q3SET THE TIME ZONE, You have not set the time zone, date and time. This message 25DATE AND TIME appears each time you turn the power on until you set thetime zone, date and time.CHANGE THE Battery pack is exhausted. Replace or charge the battery 16BATTERY PACK 3ack.THE TAPE ISSET FOR Cassette is protected. Replace the cassette or change the 23ERASURE PREVENTION 3osition of the protect switch.REMOVE THE Camcorder stopped operating to protect the tape. Unload 22CASSETTE and reload the cassette.CHECK THE DV INPUT DV cable is not connected, or the connected digital device is 99turned off.CONDENSATION HAS Condensation has been detected in the camcorder. 162BEEN DETECTEDTAPE END Tape reached the end. Rewind the tape or replace the 37cassette.CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a 56[REC MODE] tape recorded in a mode other than the SP mode.CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 105[AUDIO MODE] recorded in 16-bit or 12-bit 4-channel sound.CHECK THE CASSETTE You attempted to perform audio dubbing or AV insert on a 103[BLANK[ tape with a blank section.HEADS DIRTY, USE Video heads are dirty. Clean the video heads. 161CLEANING CASSETTECOPYRIGHTPROTECTED You attempted to play back a copyright protected tape. 100PLAYBACK ISRESTRICTEDCOPYRIGHT You attempted to dub a copyright protected tape. May also 100PROTECTED DUBBING appear when an anomalous signal is received during analogRESTRICTED line-in recording, or during analog-digital conversion of acopyright protected tape.157