Start HereEasy Setup Instructions1 Unpack and install the machine.Check the package contents.A printer cable is not included. You must purchase a USB cable (less than 10 ft./3 m) to connect yourmachine to a computer.2 Connect the power cord.1 Connect the power cord.1. Connect one end of the power cord to the rear of the machine.2. Connect the other end to the AC outlet.2 If the message appears, go to Step 4, "Install the print head."3 Load the paper.1 Open the Paper Support, then pull out the extension.2 Load a few sheets of letter-size blank paper into the Auto Sheet Feeder.4 Install the print head.1 Ensure that the Paper Output Tray isopen. Then lift the Scanning Unit(Printer Cover) until it locks into place.IMPORTANTBe sure to hold the Scanning Unit firmly with onehand.6 Lower the lock lever.5 Install the ink tanks.1 Prepare the ink tanks.2 Insert the ink tanks.3 Close the Inner Covers and the Scanning Unit (Printer Cover).6 Align the print head from the Operation Panel.Be sure to align the print head to ensure print quality.1 Press [OK] to start print head alignment.If the printed pattern matches the illustration, print head alignment is complete.You can change the language displayed on the LCD.For details, see "Selecting The Language For The LCD" in the Quick Start Guide.Hardware setup and print head alignment is complete.If you are connecting the machine to a computer for use, see the rear side of this sheet forinstructions on installing the software.Thank you for purchasing the Canon PIXMA MP760. To prepare your machine for use, please follow theseEasy Setup Instructions before referring to any other documentation.IMPORTANTDo not connect the USB cable until after the software is installed. See the rear side of this sheet for details.• Machine • Power cord• Print head• Ink tanksBlack BCI-3eBK Black BCI-6BKCyan BCI-6CMagenta BCI-6MYellow BCI-6Y• Easy Setup Instructions • Quick Start Guide• Setup CD-ROM (Windows: silver, Macintosh: white)The Setup CD-ROM contains the MP Drivers, as well as the User's Guide, Software Guide and PhotoApplication Guide in electronic format. Please read these guides.2 Remove shipping tape from theInner Cover and Open Both InnerCovers.3 Raise the lock lever.READ THIS SHEET FIRSTMP760(1) Open the PaperSupport.(2) Pull out the extensionuntil it stops.Pinch and adjustthe paper guideto the width ofthe stack.Load the paper with the print side face up.Ensure the paper stackdoes not exceed the paperlimit mark.(1) If the Paper OutputTray is not open,press the OpenButton. (3) Lift theScanningUnit.(2) PulltheScanningUnitLever.ClickInner CoversThe Print Head Holder moves to the center.Do not touch the Print Head Holder while it ismoving.Touch only the lock lever!Raise lock levercompletely.4 Prepare the print head. 5 Insert the print head.Do not touch!Remove the protective cap and discard it.(2) Push back.(1) Insert.Do not touch!Lower the lock leveruntil you hear a clickas it locks into place.ClickRemove the orange-coloredprotective film. If it is notremoved completely,problems with printingmay occur.Remove the protective capand discard it.Do not touch!Press down until the inktank clicks into place.ClickBad example. Tank 6Bk isnot fully inserted. Makesure to press it down untilyou hear a click.Good exampleClose the two Inner Covers.ClickClickIMPORTANTBe sure to hold the Scanning Unit firmly with one hand.Pull the Scanning Unit Levertowards you to close theScanning Unit.(1) This message appears.If this messagedoes not appearafter closing theScanning Unit,see "AligningThe Print HeadAutomatically"in the Quick StartGuide.(4) The machine will printthe print head positionpattern and automaticallyalign the print head.(2) Press [ ] to select .(3) Press [OK].Canon and BCI are registered trademarks and PIXMA is a trademark of Canon Inc. in the UnitedStates and may also be registered trademarks or trademarks in other countries.All other products and brand names are registered trademarks or trademarks of their respective owners.Specifications subject to change without notice.HT7-0228-000-V.1.0 © CANON INC. 2004 PRINTED IN CHINA