234156-A54231CDEBAFJHKIGActionReference InformationEnter the access point name/network name(SSID) in SSID (C).Click Manual Setup (B).When the Confirm Connection AccessPoint screen appears, click No (A).Enter the access point name/network name (SSID) and security setting (WEP, WPA,etc.) directly.Follow the procedure below.Configuring the Access Point's Wireless LAN Settings ManuallyThe Detected Access Points List screen isdisplayed.•Go to either of the following steps accordingto the selected Encryption Method (securityprotocol).•DisableWEPWPA/WPA2Go to .Go to on page 8.Go to on page 8.The Manual Setup screen is displayed.•Perform to in "Install the Software (2)" on page 27 in the printed manual:Getting Started.Select the security protocol for the accesspoint in Encryption Method (D), then clickConfiguration (E).When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.•When WEP (Transitional Security Network) is selected in AirPort Utility, select 128bit.•WEP(P.8)Select Authentication (J), then click OK (K).Go to on page 8.Select Key ID (I).Enter upper and lower case letters of the alphabet correctly when the network key is5 or 13 characters. Letters are case sensitive.Letters are not case sensitive if the network key is 10 or 26 characters (digits).•Select Key Length (G).Select Characters when the network key is 5 or 13 characters.Select Hexadecimal when it is 10 or 26 characters (digits).•Select Key Format (H).When using AirPort, select 1 in the screen.Selecting other key numbers will disable the connection between the machine andAirPort.•Enter the network key in WEP Key (F).If the Detected Access Points List screen isdisplayed, go to .•WPA/WPA2Disable(P.8)