Canon PIXMA MX410 Network Setup Manual

Also see for PIXMA MX410 Series: Menu guide Specifications Getting started guide Manual Function manual

Contents

ACheckCheckProblems during Software InstallationThe Target Access Point is Not Displayed (Detected) on the DetectedAccess Points List ScreenMake sure that you follow "Connection Checklist"on page 11, then click Refresh (A) to search for theaccess point again.Check 1Turn off the access point, turn it back on, then clickRefresh (A) to search for the access point again.Check 2Is SSID broadcast (connection via "ANY" SSID, etc.) disabled or is the stealth modeenabled on the access point?For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Enable SSID broadcast (connection via "ANY" SSID, etc.) or disable the stealth mode,then click Refresh (A) to search for the access point again.For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•To establish a connection without changing the access point settings, refer to andonward in "Configuring Wireless LAN Settings Manually" on page 8.Check 3If the target access point is not displayed on theDetected Access Points List screen, check thefollowing points.Is "WPA/WPA2 Enterprise" set as a security protocol (encryption standard) on theaccess point?"WPA/WPA2 Enterprise" is not supported on the machine.Change the security protocol (encryption standard) for the access point, then configuresettings again.For details on how to change the security protocol (encryption standard) for the access point,refer to the manual supplied with the access point or contact its manufacturer.•For the procedure to configure settings of the machine, refer to "7 Set Up a Wireless Connection"in the printed manual: Getting Started.•An access point's periodic transmission of a signal revealing its SSID.Stealth mode•A function to prevent the SSID of the access point from appearing on other wireless devices.SSID broadcast•GlossaryCheck 4An identifier to identify the specific access point. Also called an access point name or a network name.SSID•The message appears when no access point can be detected.Click OK to display the Detected Access Points List screen,then try to detect the access point again by referring to "TheTarget Access Point is Not Displayed (Detected) on theDetected Access Points List Screen" on page 2.An access point could not be detected. is Displayed