Canon PIXMA MX410 Network Setup Manual

Also see for PIXMA MX410 Series: Menu guide Specifications Getting started guide Manual Function manual

Contents

23415 CDEBAReference InformationEnter the access point name/network name(SSID) in SSID (C).Click Manual Setup (B).When the Confirm Connection AccessPoint screen appears, click No (A).Enter the access point name/network name (SSID) and security setting (WEP, WPA,etc.) directly.Follow the procedure below.Configuring Wireless LAN Settings ManuallyThe Detected Access Points List screen isdisplayed.•Go to either of the following steps accordingto the selected Encryption Method (securityprotocol).•DisableWEPWPA/WPA2Go to on page 9.Go to on page 9.Go to on page 9.The Manual Setup screen is displayed.•Perform to in "Software Installation (1)" in the printed manual: Getting Started.Select the security protocol for the accesspoint in Encryption Method (D), then clickConfiguration (E).If the Detected Access Points List screen is displayed, go to .•ActionCheckCheckOther Troubleshooting TipsThe Machine is Not Detected after the Network Environment is ChangedIP address•A numerical identification assigned to each computer or network device connected to a network.GlossaryWait until the IP address is assigned to the computer. You may need to restart yourcomputer.Search for the machine again after confirming a valid IP address is assigned to the computer.•Forgotten or Do Not Know the Access Point Name/Network Name(SSID), Security Protocol (encryption standard), and Network KeyCheck the access point settings.For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•