4 Preparing the PrinterENGLISHPreparing the PrinterBe sure to read your setup sheet first for setting up your printer and getting it ready for use.Unpack the printerPlease confirm the included items against the illustration printed on the lid of the packing box.1 Turn on the printer.2 Install the Print Head.3 Install the ink tanks.ImportantA USB cable is necessary to connect the printer with your computer.CautionBe sure to remove the tapes before you turn on the printer.NoteThe tape position is subject to change.CautionDo not touch internal parts other than the Print Head Lock Lever.ImportantDo not reattach the protective cap once it has been removed.Notez If the Print Head was not installed properly, raise the Print Head Lock Lever and remove thePrint Head. Follow the directions given in step 3 of your setup sheet to reinstall the Print Head.z There may be some transparent or light blue ink on the inside of the bag the print head comesin, or the inside of the protective cap - this has no effect on print quality. Be careful not to get inkon yourself when handling these items.Importantz If the Top Cover is open for more than 10 minutes, the Print Head Holder moves to the rightside. In this case, close the Top Cover, and open it again.z Make sure that all the ink tanks are installed in the correct position, matching the label. Theprinter cannot be used unless all the ink tanks are installed.z Once you have installed the ink tanks, the POWER lamp will flash green. Wait for about2 minutes, until the POWER lamp stops flashing and changes to steady, non-flashing green andthe printer has stopped making operating noises, before proceeding.Notez Be sure to remove the clear film from the ink tank in the exact order as shown in step 3 of yoursetup sheet.z Do not squeeze the side of ink tanks as this may cause the ink to leak out and stain your clothesand hands.z Do not reattach the protective cap once you have removed it.z The ALARM lamp on the printer still flashes orange if an ink tank is not installed properly. Openthe Top Cover and make sure that position of all the ink tanks match the label.
