60The Printer NetworkSetup dialog box isdisplayed during setupThe Printer Network Setup dialog box is displayed in the following cases.- when you are re-setting a printer whose setup was canceled halfway- when you changed the network settings- when you are already using a printer over a wireless or wired LANIf you canceled setup or changed the network settings, perform network setupagain. When you intend to use the printer connected to the network with thecurrent settings, do not change the network settings.Change printer settingsThe printer network settings will be changed to enable communication underthe current network settings.Do not change printer settingsContinues computer setup with the settings specified to the printer.Select this when you are not currently connected to a network but want to setup the computer with the settings specified to the printer.After setup, confirm that the printer and the computer (or the access point, when usingwireless LAN) can communicate with each other. If not, perform network setup again.The Enter Password /Password Input dialogbox is displayed duringsetupThe following dialog box is displayed if an administrator password is set to theprinter which has already been set up.Admin PasswordEnter the administrator password you have set. The administrator passwordconsists of alphanumeric characters and is no longer than 32 characters. Thepassword is case sensitive.For security, your entry will be displayed by “*” (asterisks) for Windows and “•”(bullets) for Macintosh.The You haveconnected the printerto an unsecuredwireless network isdisplayed during setupSecurity is not configured on the access point.The printer can still be used, so continue the setup procedure to complete it.If you connect to a network that is not protected with security measures, there is a risk ofdisclosing data such as your personal information to a third party.Problem Possible Cause and Measures