Canon Pixma MG6821 Online Manual

Also see for MG6800 Series: Getting started Online manual Getting started Getting started

Print settings• Prevent paper abrasionUse this setting only if the print surface becomes smudged.Important• Be sure to set this back to OFF after printing since it may result in lower printing speed or lowerprint quality.• Extended copy amountSelects the amount of image that extends off the paper when printing in borderless (full).Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. Youcan change the width to be cropped from the borders of the original image as needed.Important• This setting can be applied under the following conditions:- Performing borderless copying- Borderless is selected for Border when copying printed photosNote• If printouts contain margins even though you are printing in Borderless, specifying Extendedamount: Large for this setting may help solve the problem.• Auto photo fix settingWhen ON is selected, you can select whether to print photos using the Exif information recorded in theimage files in the following cases.◦ Auto photo fix is selected for Photo fix when printing from a memory card.◦ The print setting on the PictBridge (Wireless LAN) compliant device is set to Default* or On whenprinting with a PictBridge (Wireless LAN) compliant device.* When Default is selected for the print setting on the PictBridge (Wireless LAN) compliant device,select Auto photo fix for Photo fix in PictBridge print settings.• Prevent paper double-feedSelect ON to prevent double-feed of plain paper.Important• Select ON only when double-feed of plain paper occurs.• Adjust horizontal print positionAdjusts the print position when the left/right margins are not aligned.You can adjust the left/right margins in increments of 0.003 inches/0.1 mm between -0.1 inches/-3 mmand +0.1 inches/+3 mm centered on the horizontal center of the paper.Important• For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.05inches/-1.5 mm and +0.05 inches/+1.5 mm even if you specify the value over 0.05 inches/1.5 mm.262