Canon VC-200 Instructions Manual

Also see for VC-200: Instructions

Correct the characterCorrections must be made while in the recordpause mode. To make a correction, first press dis¬play button ® (LOCATION button) until the char¬acter you wish to change blinks. Then press dis¬play button ® (CHARACTER [DEL] button) toselect the correct character.• Character changes will begin with the nextletter (or number) in the sequence.• To delete a character, select the cursor (the lastcharacter in the set) with display button ®(CHARACTER [DEL] button).To record the completed title, press the camera’sstart/stop button; any remaining cursors willdisappear.• The blinking “REC" display, which appears inthe top right corner, will not be recorded.• The above procedure is for superimposing atitle on the scene you are shooting. If you wouldlike to record just the title on a blank back¬ground, cover the lens with a cap or some othersuitable item.To delete the title during recording, press displaybutton® (CHARACTER [DEL] button). The title willdisappear from view, but it is retained in titlememory.• Title deletion is possible only during recording.If you wish to display the title after deleting it,press the camera’s start/stop button again toplace the camera in the record pause mode. Thetitle and cursors which denote blank spaces willreappear (the left cursor will be blinking).• If you don't wish to record the title the next timeyou shoot, switch the title mode to the EVF infor¬mation mode with the mode select button.• The constructed title will be retained even ifrecording is stopped, the viewfinder display ischanged to another mode (such as the EVF in¬formation or stopwatch mode), the camera isset to standby, or the recording is played backin the viewfinder, as long as the recorder’s VTRswitch is set to ON and the camera cable isconnected.